- Plot # 94 Rd #16, MIDC Andheri East , Mumbai, India.
Spur gears transfer rotary motion between parallel shafts. They have straight teeth which are parallel to the shaft on which the gear is mounted.Spur gears are relatively simple in design and manufacture due to their structure.
View more
Helical gears are used where higher load bearing capacities are required in prime movers and power applications. The teeth are having a inclination ranging from few degrees to up to 30 degrees or more depending on the gear application.
View more
Double helical gears have more than double the contact gear tooth area compared to single helical gears and hence have more load and power transmitting abilities. These gears also operate at low noise levels and high speeds.
View more
We have internal and external shaper cutting capabilities up to 1800 mm diameter with up to a 150 mm gear face, and of 1600 mm diameter with 275 mm face width.
View more
Are you looking for Internal and external splines ? Marshall makes both of these and can offer competitive rates for both Internal and External spline cutting.
View more
Worm gears are usually used when large speed reductions are needed. The reduction ratio is determined by the number of starts of the worm and number of teeth on the worm gear.
View more
We at Marshall Gears are the industry leaders in manufacturing of Large sized Industrial sprocket gears. Sprocket gears are one of the many types of gears that are used for Mining, Conveyor, Dryers, Kilns and other similar applications.
View more
Crowned Gears are necessary for applications where noise is a concern and self alignment is required. Crowning gear teeth reduces noise by alleviating misalignment through either assembly or thrust problems.
View more
We can manufacture Custom Module or Even Unknown Module Gears and Pinions. Get in touch with details about your specific custom requirements.
View more
Top
